A Sunfire distributor cap can be removed with some simple tools. One way is to use a standard wrench and a towel.
The distributor cap is located on the top of the distributor on a 1996 Sunfire. It is connected to the spark plugs via a wire.
there isn't one. its distributorless.
On the 2.8L V6 the distributor cap is held on with two screws. Unscrew the two screws and pull straight up on the distributor cap to remove it from the distributor.
What it will cost you to replace the distributor cap on a Pontiac Sunfire will vary depending on if you do it yourself or if you take it to a garage. The cost can be over $100 if you take your car to a garage.
There is no distributor cap on a Pontiac sunfire, only a coil pack. coil pack is located on the back of the engine.
on this old distributor there is a cap that holds the wires in place on the distributor. Is there a trick to remove top cap?
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
To remove the distributor on an EA Falcon, first remove the distributor cap. Use an extension bar to reach and remove the small lug that holds the distributor.
It's the distributor rotor that you are looking for & it's under the distributor cap. Remove the distributor cap and there you will find the rotor.
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil
The ignition coil should be inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
on the bulkhead, nearside. near the dipstick. it should beinside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
how do you remove and replace the distributor cap on a 97 chevy cavalier?. I can not get to it.
how do you remove a distributor rotor on a 92 Nissan sentra
In the distributor. You have to remove the distributor cap to gain access to it.
On top of each spark plog. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
It's inside the distributor cap. Remove distributor cap, remove two 8mm nuts and four small Phillips head bolts. Slide coil up out of distributor.
Probably - remove distributor cap and look
UNDER THE CENTER/ CUP HOLDER CONSEL. REMOVE CONSEL DISTRIBUTOR CAP SHOULD BE ON TOP.
rotor should point at number 1 plug lead when engine is at tdc make a mark with whiteout ,on outside of distributor before you remove distributor cap. make this mark where the #1 spark plug lead would be if distributor cap was on distributor when you remove cap this is where rotor needs to be pointing
Rotate engine to TDC Intake Stroke Remove Distributor cap Remove vacuum line to vacuum advance if equipped Remove horsehoe type clamp on side of distributor Lift out distributor
In the distributor,you need to remove the dist cap & then remove the rotor and it will be mounted to the distributor housing
First unhook the battery. Next, remove the distributor cap and unhook the wire that runs to the coil. Then loosen the distributor clamp (10mm nut) and pull the distributor out.