It's the distributor rotor that you are looking for & it's under the distributor cap. Remove the distributor cap and there you will find the rotor.
It is located on the distributor under the cap and rotor.
I just replaced one on my 1992 astro and it was $120 just for the distributor not including the rotor and cap
When I tuned up my 99. I changed, plugs, wires, distributor cap, rotor and ignition coil. To my knowledge that is about all you can do. I would by the cap and rotor from the dealer. I made the mistake of not doing that and had problems with the aftermarket cap and rotor getting corroded.
you dont
Under the distributor cap.
Plug wires are installed incorrectly.
It is located on the distributor under the cap and rotor Crank sensor should be on the front bottom of engine by the crank pulley
The rotor button is inside the distributor cap.
On a 1995 Chevrolet Caprice Classic, the distributor cap and rotor are located on the front of the engine, typically near the intake manifold. The distributor is mounted on the engine block, and you can access the cap by removing any obstructions, such as the air intake duct. The rotor is situated inside the cap and can be accessed by removing the cap itself.
Yes, while you are changing, check the distributor gear for wear, common issue.
Unbolt distributor cap. lift rotor off, remove and install new cam sensor (pick up plate) and reinstall rotor and cap.
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.