Want this question answered?
The spare wheel is on the Citroen Berlingo is underneath the rear of the van. Place the jack into the vertical tube on the left rear of wheel retaining bracket. Open the rear doors on the van, and look for two squares of plastic with cut-out slits on each side. Insert a screwdriver into the slits to lift off. Loosen the bolts under the plastic squares, but do not take completely off. Swing the bracket clear, lower the jack, and remove the wheel.
The brake light bald can be accessed through the trunk of the car. Remove the rear tail light cover to access the brake light bulb.
Put in Berlingo springs, they are taller and harder, but will fit.
If you have ABS there are no valves, If no ABS they are under the rear of the car attached to the rear suspension with a spring. From the Haynes Manual
maybe it is because the outside locks are broken
First remove the plastic cover of the rear door. You need a screw driver to pull the cover clips out of it's hole. You can see the back side of the plate light unit through an open path just beside the rear wiper motor. Push the clip gently and take out the whole unit and change the bulb.
It tips forward. remove headrest, and release to sprung catches at rear of seat, it then will tip forward
the rear speakers are located in the back doors. you have to remove the door panels to get at them.
On the drivers side about 20cm in front of the rear wheel, attached to the fuel tank. It is a small cylinder... looks like a shrunken can of baked beans, with fuel pipes attached to each end. Hope this helps.
citroen saxo 1.4. what is the rear brake hub torque setting?
Access is from inside of vehicle under boot carpet below offside rear passenger seat.
The ones in the front doors aren't covers, they just look like it. You have to remove the door panel to get to the speakers. The rear deck comes off by removing the rear seat and the rear interior panels. After you do those things you can slide the rear deck off and expose the rear speakers.