How to set the distributor in a 1995 Honda civic
the ignition module is located in the distributor
check the distributor
I think you will find its a td42
To remove the distributor on a 1995 Toyota Previa, first disconnect the negative battery terminal to prevent any electrical issues. Then, remove the ignition wires from the distributor cap, followed by the cap itself. Next, unbolt the distributor from the engine block and gently twist it while pulling upwards to detach it from the engine. Be sure to mark the position of the distributor for reinstallation.
Try the main relay. Mine was behind the glovebox on a 1996 civic. Good luck.
It takes about .9 of an hour to change regardless of which engine you have.(book time) it is located on the distributor, you have to remove the distributor to check it and/or replace it.
EAsy , remove distributor cap then loosen two screws holding rotor down and pull it off . reassembly is reverse of removal
because its a 1995 honda civic
Remove the distributor cap and rotor. Now look in the distributor and you will see an electronic device that has 2 different electrical connectors on it. That will be the module. remove the 2 screws and take it out.
17 mm.
Honda radioremoving Honda radio installing sony radio