How do you remove a door panel in a 95 jimmy?

Answer 1

1. Remove the screw holding the door-open handle bezel, and remove the bezel. Unhook the power door lock switch (if equipped) and set the bezel aside.

2. Carefully remove the power window switch from it's bezzel. There are 4 small clips, 2 on each side of the switch. Once you remove the switch from the bezel, the bezzel can be gently pried out the top of the panel w/ a small screw driver from the front.

3. Starting at the front w/ a small screw driver, pry out (gently!) the trim inlay that's above the arm rest... it was wood-grained plastic on this model.

4. Use a #30 torq bit to remove the large screw towards the top of the opening where the trim inlay was.

5. Remove the 4 Philips head screws around the perimeter of the door panel.

6. Lift up on the door panel... you may have to shake it a bit.... and after moving upwards no more that an inch... the panel should come off.

Answer 2

You will need a Phillips head screw driver, 10mm socket depending on yr., a plastic pry bar, and a flat head screw driver. 1st open door compltely. Take off the door lock position indicator with pry bar. take off power window and lock controls. Behind door handle there is a panel remove with pry bar. under this panel is a screw remove it. at the very bottom of door there is 1-3 screws remover them. check for any other screws. Starting at the lowest part of door closest to jam insert pry bar behind door facia. work your way around till door has completely released. lift from bottom till window seal is free then sit door facia on a towel or blanket to prevent scratching.

Answer 3

First you have to unscrew the door handle bezels and remove them from the door panel. Then unbolt the door pull from the door of the car.

Next you have to pry the door panel tabs off of the door.

Answer 4

there is little panel you must remove in the pocket under the door handle, there are two 7mm screws you have to take out. then take out the little plastic Phillips head screw behind the door handle. you have to pop out the little squar push pin the Phillips head screw was just in, use a pic tool. hears the tricky part, the plastic panels in these trucks break very easy so take your time but be firm when doing this, use a panel popper if you have one, go along the rim of the plastic molding hat surrounds the door handle, watch that you don't rip the leather or fabric around the piece, you have to pop that piece out so it will slide through the opening when you get the door panel off. remove the two trim pieces that run along the window, then start at one end of the panel and work your way to the other pulling on the panel until it pops free at each point. unplug the harnesses inside the panel and your done.

Answer 5

To remove the rear door panel in your Chevy HHR, you will need to remove the two screws located inside of the door pull cup, and there's also one in the middle of the inside door handle.

On the outer edge of the door there's also a pin the holds the panel in place, you will need to remove that. Then use a door panel removal tool to pry the door panel off of the HHR rear door.

An instructional video has also been enclosed below that shows this entire process and where everything's located.

Hope this helps,

1ATony

Answer 6

Use a screwdriver to remove all screws and clips in the door panel, and gently pull the panel away from the frame. Remove any wiring connections, and the panel will come off of the frame.