Depending on the year, but i have a 95 and there are screws going around the outside ov the door panel remove those
take it to a good body shop with a qualified tech!
The sensors that tell the car when the door is opened or closed are garbage.
There are 2 screws in the bottom of the door and 2 more under the door handle in the inside of the car just pop it off at the seems and screws will be inside pop panel off and unplug the power locks
To remove the driver side paneling of a 1967 Mustang window, first, ensure the window is fully closed and disconnect the car battery. Use a flathead screwdriver to gently pry off any trim pieces or clips around the panel. Next, remove the screws securing the panel, typically located near the armrest and door handle. Finally, pull the panel away from the door, taking care to disconnect any wiring for power windows or locks if equipped.
first remove all the paneling in the trunk then you need to disconet the lines under the car,it a pain in the butt...
Gas-axe.
un lock the car using the remote, then push on the gas door and it will pop open
Jetta is a type of car.
Just left of the foot rest, by the door. Pull out and towards the outside of the car for best results. Based of my 2003 Jetta TDI.
smash the door off
Press the red button at the side of the seat. You can then open the door and leave the car.
open the door then drive into it with another car and it should remove it safely if not just use a hammer