Insert a flat head screw driver on the 2 clips that prevent it from pulling out and push down.You can see a pic of the 2 clips at jlkautoparts.com
Very carefully(;
It is very simple. In the center of the holder when is pulled out as far as it will go, use a srewdriver blade to push down the tab. The cup holder will now pull out.
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
To remove the cup holder from a Ford Freestar, first, locate the screws or clips securing it in place. You may need to use a screwdriver to remove any visible screws. Once the screws are removed, gently pull the cup holder out of its slot; it may require some wiggling to detach it fully. If it’s stuck, check for any additional fasteners or tabs that need to be released.
Open the cup holder and remove the two screws on the outside.
Remove original ashtray, remove 4 screws that hold ashtray mounting bracket. This will give access to the 2 screws that hold inner end of cup holder. The cup holder must be pulled all the way out to get to screws. Remove screws, remove 2 screws in front face, cup holder will come right out. Installed updated cup holder in 20 minutes, start to finish!
I cannot find how to remove the cup holder from the dash of my 2001 Pontiac Montana
Pull the cup holder out. Reach back, and at the top rear, center-left, is a tab. Press the tab down and pull out on the cup holder to remove it.
the rear cup holder in my 1997 ford explorer keeps falling
To remove the cup holder from a 2005 Acura RL, start by using a flathead screwdriver to gently pry off the trim panel surrounding the cup holder. Once the trim is removed, locate the screws or clips securing the cup holder in place and remove them. Carefully pull the cup holder out of its housing, ensuring not to damage any surrounding components. Reassemble by following the steps in reverse order.
Dude, there is no such thing as a 19999 f-250; but if you are talking about a 1999 ford then ask your local mechanic.
To remove the rear cup holder from a 2005 VW Beetle, start by gently prying off the trim panel surrounding the cup holder using a flathead screwdriver or a trim removal tool. Once the panel is removed, look for screws or clips securing the cup holder in place and remove them. After that, you can pull the cup holder out of its housing. Be careful not to damage any surrounding components during the removal process.