Chevy Silverado
Oldsmobile Intrigue
Honda Accord EX
US Governors

How do you remove a governor from a 1998 Oldsmobile intrigue GL?

181920

Top Answer
User Avatar
Wiki User
2007-06-27 18:58:08
2007-06-27 18:58:08

You can't take off the "governor" on any computerized car.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The fuse panel cover is on the passenger side in a 1998 Oldsmobile intrigue. Same location as vehicles that have it on driver side. Just pull on it and it will pop off.

User Avatar

Remove the serpentine belt and the altenator. The water pump is behind the alternator. Make sure to drain the antifreeze.

User Avatar

you have to remove the bracket that goes over the top of the battery then its just a matter of unbolting the hold down bracket and the cables

User Avatar

The 1998 Oldsmobile Intrigue gets an estimated 19 mpg in the city. The vehicle gets an estimated 30 mpg highway mileage.

User Avatar

The Antenna is built into the rear window.

User Avatar

You will need to remove the water supply hoses from your 1998 Oldsmobile Intrigue heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.

User Avatar

http://www.youtube.com/watch?v=QKdDTupYOCM Its for a 1998 Buick Century, but I believe it is the same on the Intrigue

User Avatar

What does 'service engine soon' light mean on a 1998 olds intrigue?

User Avatar

passenger side of the motor must remove the serpentine belt there is a diagram on the left side of the motor compartment

User Avatar

The 1998 Oldsmobile Intrigue turn signal flasher control module is below the dashboard on the drivers side of the passenger compartment. The signal flasher control module should be labeled as such.

User Avatar

Most parts on the 1998 through 2002 Olds Intrigues are interchangeable.

User Avatar

On the 1998 Intrigue it is on the rear side of the radiator, in the lower left hand (driver) side. May need to remove the lower shroud (5 bolts) to gain access more easily.

User Avatar

Oldsmobile didn't make a Cutlass Supreme in 1998

User Avatar

It's built in to the circuitry of the alternator. It's not serviceable separately.

User Avatar

Low pressure port - Larger hose from air compressor

User Avatar

Alldata, haynes manual, or the sticker on the hood.

User Avatar

The Oldsmobile Intrigue does not have a timing belt. It uses gears. For cars that do have a timing belt, about 60,000 miles. But remember than some engines don't use one.

User Avatar

under the ignition coils. it is flat comes off after you remove the three numbered igniton coils. they plug into the module underneath them.

User Avatar

If you get the PCM, engine wiring harness, and intake manifold from the Regal also..

User Avatar

Three Auto Upholster store tried to remove the visors from my 1998 Oldsmobile without success. My visor are literally disintegrating. I can't find replacement any place. I printed the pictures to them and followed them to no avail. (?) Please any recommendation will be highly appreciated. alvgcontact@gmail.com


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.