Pop back the plastic cover from the center of the crank and remove Allen or Philips screw. Handle will then pull off.
Disconnect the positive cable from battery, carefully remove the bolts attaching door panel and disconnect electrical connections and lower window before disconnecting battery and remove the two bolts holding the door handle on and remove the linkage and reverse for installing.
Remove door panel for access and investigation
Pop out the switch panel and remove the two screws disconnect the wiring and reinstall the new switch
It snaps in and laps over lower part of window one bolt by door handle
tilt the handle(gently so as not to do any damage on any parts) to be able to expose the connection of the handle to the door panel. you will see a clip that locks the plastic handle to a metal shafting. using a metal tool (a pusher, or a flat screw driver), gently remove the clip and then pull the handle.
You have to remove the door panel...not easy, but do-able. Once that is off you can remove the door handle and replace it.
right behind the wide part of the handle that goes through the door there is a u shaped clip you get a hooked tool and just fish around behind it and pull it off and the handle will pull right off
HIT IT WITH A MALLEt
You will need to remove the door panel of your 1995 Toyota. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
If you do not see one above the door window it does not have one.
remove back seat, remove screws bottom and top of panel, remove panel. remove 3 bolts and motor arm, window and regulator will pull out.