answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-08-17 05:24:21

Unhook the battery pull switch out to headlight on position reach under dash to switch , will be a small button on it , push the button at same time pull on switch knob the know and stem will come out use a wide bladed driver and remove the nut that holds the switch in from front of dash unplug wiring remove

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions



Behind the dash, on the headlight switch itself, there is a "pin" that you have to push in in order to pull out the light knob. Feel under the dash, the pin is toward the back of the switch. When you push it in, with your other hand, move the light knob in and out. It will come out. Then, you can remove the nut, take the switch out from behind the dash.


The features that came on the 1972 Chevelle were very different from all of the other model years of the Chevelle. The features were standard light up air bags, reclining trunks and 1973 technology that wasn't seen until the next year.


How do you install a stop light switch on a 1972 cougar


to remove the ignition switch from a 72 Chevy first remove the steering wheel, then remove the three screws that hold the turn signal assembly the turn signalhandle will unscrew if there is no cruse control if there is the handle will have a screw holding it in place this must be removed under the turn signal assembly there is a screw usually a #27 torx remove this and your ignition switch will slide right out


if the buick is also an A body they will work as the chevelle is an A body.


The Chevelle convertible was available from 1964-1972.


# Drain the radiator below the thermostat level # Remove the water outlet elbow assembly from the engine and the remove the thermostat


the 1970 Chevelle had 500 hp stock and 500 pounds of torque. The 1972 chevelle 454 was SAE rated @ 270 horsepower



You will have to remove the instrument cluster to gain access. You might want to purchase a Haynes Manual that will instruct you.


No they will not. Only 1970-1972 doors will fit on a 1970 Chevelle. 1969 is only interchangeable with 1968.


Remove the dash cover. There is 2 screws in the top of the glove box. Then on the drivers side to the center is about 4 or 5. Remove the dash cover and you have access to the back of the instrument panel. The light sockets turn 1/4 turn to come out.


It WILL fit. However, the 1970 bumper has turn signals in it where the '71-'72 front bumpers do not.




Depends on the engine, transmission, gearing, etc.


All depends on the engine in it and the rear gear ratio.


Loose belt, bad wire connections, or bad alternator. Your local parts store should be able to test the alternator for you.


Contact Ausley's, or Year 1, online.


Right above the front license plate.


depends on the engine in the car and the gearing in the rearend.


It should just have a slide clip that holds it in.


Register with Auto Zone and the diagrams are free




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.