Should be a bolt in each corner of the seat and disconnect wiring harness
To remove the seats from a 1995 Corvette, you will need to remove the front and rear nuts from the seat frame studs. You will?æalso need to remove the lug wrench that is attached to the seat frame studs.
== ==
Remove four bolts. Lift it out.
Remove the two Allen bolts at the rear of the seat with a hex wrench, then slide the seat backwards.
look around the bottom of the seat their should be bolts leading through the floor board take those out (their should be 4 of them) and just remove the seat.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
Four bolts hold the seats in. Pull the seat all the way forward & remove the two bolts behind the seat (one each side). Push the seat all the way back & remove the front bolts. The seat should come right out (mine did!).
If you are talking about removing the entire seat ther are 4 bolts on the undercarraige that fasten it. One side is bolt from bottom.
STORAGE COMPARTMENT Uder storage tray is the Bosch brake cotroller
what is the process for installing new seat covers in a 1977 chevrolet corvette
there should be 4 bolts that hold the seat to the floor. just remove them and if it has power seat dont forget to unplug them.