If you are talking about removing the entire seat ther are 4 bolts on the undercarraige that fasten it. One side is bolt from bottom.
To remove the seats from a 1995 Corvette, you will need to remove the front and rear nuts from the seat frame studs. You will?æalso need to remove the lug wrench that is attached to the seat frame studs.
Behind the driver's seat.
== ==
Remove four bolts. Lift it out.
the easy way is to un clip the seat the clip is located under the front seat cushion by filcking the wire clip back its a wire clip lift cushion off then there are four bolts which unbolts seat to frame you will need to unplug wiring for seat motor you will see when you remove cushion then lift seat out
It's in the compartment behind the passenger seat. Lift out the box and it should be there.
Put your head down in the footwell and look at the bottom (center) of the seat. You will see a small silver wire about 3" long. Push this wire down and back toward the back of the seat, when it pops down simply pull the seat cushion up.
To remove the seat from a 1958 Corvette, first, slide the seat all the way forward to access the rear mounting bolts. Use a socket wrench to remove the bolts securing the seat to the floor. After removing the rear bolts, slide the seat back to access and remove the front bolts in the same manner. Once all bolts are removed, carefully lift the seat out of the vehicle.
Remove the nuts! They are on the lower metal frame the seat
Should be a bolt in each corner of the seat and disconnect wiring harness
Open hatch behind drivers seat......remove battery cables.....remove battery hold down clamp at lower back flange of battery...pull out battery....replace in reverse order.
Check behind passenger seat. Lift out compartment tray, it should be there