Some are removable from the exterior. Remove brake drum. There should be 4 bolts holding axle in place Hub should have a large hole on side to allow use of a socket to remove these bolts After bolts removed pull axle out of differential. Some have to be removed from inside the "Banjo". Not familiar with this procedure
The speed sensor is mounted in the top of the rear differential on a 1999 F150. Remove the wires, then unbolt the sensor to remove it.
how do you replace a Ford F150 rear axle seal
No, the rear axle shaft does not have an internal retainer clip. You remove the four nuts on the inside of the brake backing plate and remove the axle shaft with a slide hammer and hub adapter.
how to remove rear axle from 1988 f250 ford
Inside the rear axle.Inside the rear axle.
It is in the top of the rear axle. Remove the nut and bolt, gently twist around and pry up slowly to remove. Be carefull not to break off in the axle.
its located at the rear drive axle
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
i need to know how to get the axle shaft out of my ford f150 its a 1999 i took off the brakes the caliper i took off the back plate off the back of the pumpkin and your supposed to pull a c clip off and slide out the axle but how do you get the c clip off i cant figure it out can anyone help me out my e-mail address is jim13kar@msn.com thank you
Remove the rear wheel from the axle. Remove the brake pads and hardware. Remove the axle end cap. Remove the bearing. Reverse the process to install the new bearing.
loosen up the rear axle nut and loosen up the axle adjusters so the rear wheel moves forward, Now remove rear brake caliper from rear brake caliper mount and the remove rear axle and lower rear wheel and slide belt off rear pully. and remove the rear wheel. http://www.ronincycleparts.com
I believe you can find the axle code on one of the stickers on the end of the drivers door - then the code is used to find out what differential gearing your F150 has