answersLogoWhite

0

If this is a 4X4, this can be a little tricky, you can access the wiring to starter through the wheel well, this starter is probably expensive, as it is smaller than the average bear. Good luck. HTH

You first need to look under your passenger wheel well and remove the nut that connects your wire to the starter (also there is another wire with a smaller nut to disconnect from the starter). Next remove the cover plate that�s directly below the front of the starter, there should be six bolts to remove. Then remove the two bolts out of the starter, after the starter is loose. You then should be able to angle the back of the starter up towards the wheel-well. Now you should have enough room to take the smaller wire off of the back of the starter. After that�s off you�re able to remove the whole starter from your car.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Where is the starter located at on a 2000 gmc jimmy?

My 2000 GMC Jimmy is slow cranking. The battery voltage meter is showing charged so I am assuming that the starter is the problem. Where do I find the starter to remove it?


How do you remove starter from 95 gmc jimmy 4x4?

To change the starter on a GMC Jimmy 95 you must look under the truck and locate the starter. There will be a bar in the way of removing the starter. You will have to remove the two screws and manuver the starter around the bar. This will be tricky so take your time. Once you remove the starter replace with the new one and manuver back in place screw in and your done.


Where is the the starter switch located on 1995 gmc jimmy?

on the side of the steering column you put your key in it and turn


Why 1995 GMC jimmy Starter makes grinding noise?

Sounds like the starter is "dragging" - happens when the bushings are worn. Can be overhauled if you are mechanicaly inclined, otherwise replace the starter.


How do you change the brake booster in a 1995 GMC Jimmy?

Begin by removing the brake lines from your 1995 GMC Jimmy brake booster. Remove the brake booster retaining bolts. Reverse the process to install your new brake booster.


How do you replace a starter in a 1995 GMC S1500 extended cab pickup?

First, remove the negative battery cable. Then remove the wires off of the starter. Then remove the 3 bolts that hold the starter on and work it out around the exhaust.


How do you remove radiator from gmc jimmy?

How to remove a bad radiator from a 1992 GMC jimmy 4x44-door,v6 engine?....Thank you :)


How do you replace a starter 2001 gmc jimmy?

To replace the starter on a 2001 GMC Jimmy, first disconnect the negative battery cable to ensure safety. Then, remove the starter's electrical connections and the mounting bolts securing the starter to the engine. Carefully pull out the old starter and install the new one by reversing the steps, ensuring all connections are secure before reconnecting the battery. Finally, test the new starter to ensure it functions properly.


How do i know if when replacing the starter on a 1995 gmc jimmy would i need to also replace the fly wheel.?

the teeth on the flywheel will be missing or damaged when you rotate it around.


Where is the starter on 1998 GMC Jimmy?

On a 1998 GMC Jimmy, the starter is located on the driver's side of the engine, near the bottom, mounted to the transmission bell housing. To access it, you may need to lift the vehicle and remove the engine cover or other components for better visibility. The starter is typically secured by bolts and connected to the battery and ignition system with electrical wires.


Where is the fuel Pump on a 1995 GMC Jimmy?

in the tank


How many seats does a 1995 GMC Jimmy have?

four