0
How do you remove a starter from a mercruiser 3.0 liter 4 cylinder inboard motor?
Wiki User
∙ 15y ago
Remove power connections from battery. Remove the wires to the starter. There are 2 bolts, one short, one long, that go from under the starter upwards. Remove these 2 bolts, loosing them each a bit at a time and holding the starter up to keep the turning easy. It is all basically a 'no-see' job, have to go by feel.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace the starter on a 1988 Chevy pickup 8 cylinder?
Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter
How do you change the starter on a 1994 Chevy s 10 with a 4 cylinder engine?
Remove - battery cable Raise and support vehicle Remove wires from top of starter Remove mounting bolts Remove starter If you cannot get to the wires there is enough wire to remove the starter and then remove the wires
What is the step by step on how to replace a starter for a 97 Chevy S10 2.2 4-cylinder?
disconnect battery. remove cables at the starter. remove starter mount bolts. remove starter. replace starter. reinstall bolts. reinstall wires. reinstall battery cable.
How do you replace starter on 1998 Chevrolet Cavaliers 2.4L 4 cylinder motor?
Remove the positive cable from your 1998 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
How do you remove the starter from a 1998 Toyota 4runner 4 cylinder?
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
What do you have to do to remove a starter for a 1988 Chevy Cheyenne 6-cylinder standard trans?
you must remove the clutch slave cylinder and line. Then unbolt the starser and install the new one
How do you change the starter in a 1992 Nissan SE Frontier pickup 6 cylinder?
disconnect neg.cable,then disconnect pos. cable from starter ,then other wire,then remove 2 bolts holding starter to engine.
Where is the starter on 2000 Subaru Outback?
its on the top drivers side under the clutch master cylinder or the brake master cylinder easy to remove three bolts i believe
What is the hydraulic cylinder under the starter of a 92 Z71 and what will happen if you remove it so the starter can be replaced?
I would think you are talking about the Rack & Penion sterring cylinder. You do not have to remove it to replace the starter.The cylinder that I think you are talking about is mounted on the front end housing and it is a 4 wheel drive actuator. nothing will happen if you remove it and install it again, but be carefull some of them have a spacer inside. Chevy trucks of that year did not use a rack and pinion steering.AnswerIf its a standard tranny prob the clutch hydralic cylinder. Answerclutch slave cylinder
How do you get to the top bolt to remove your starter on a 1993 Nissan truck 4 cylinder?
by going over the top of the bell housing
How do you remove a broken starter bolt on a 1996 Toyota Camry 4-cylinder?
get a tap and die set and follow the instructions.
How do you remove and to replace starter?
In general, remove negative cable from battery, remove electrical wires from starter, remove bolts holding starter in place, remove starter. Replace starter in reverse order.
