Do an online search for a shop manual for your make and model of car. Try http://www.ebooksquad.com/
how do you change a ac fan switch on a 1997 Chevy cavalier
No, an AC dimmer switch is designed to work with AC-powered devices, not DC. DC fans require a different type of dimmer switch specifically rated for DC power. Using an AC dimmer switch on a DC fan can potentially damage the fan or the switch itself.
does fan door motorized or on a vaccuum line when you switch from AC to defrost?
Most likely either the switch or the motor is defective.
You can bypass the AC low pressure switch, on your Toyota Corolla, by removing the switch. You can remove the wiring to the switch and leave the switch and place.
replace the switch
If you mean the compressor, then it could be: A blown fuse, bad AC switch, or low freon. If you mean the blower fan, same problems above, but add a bad fan switch, or regulator.
Generally, on most vehicles, the radiator fan is controlled by a thermostatic/electric switch. When the coolant temperature rises to the setpoint, the switch closes, applying electric current to the fan, turning it on. Then, when the coolant temprature has cooled below the setpoint, the switch opens, turnng the fan off.
a/c switch is located under the hood, passenger side and attached to the a/c dryer. may you be talking about the fan switch, vaccum controller swtch or aux switch or lever switch, that make-up the climate controller in the dash.
To remove the AC fan on a Honda Element, first, disconnect the negative battery cable for safety. Then, remove any necessary panels or covers to access the fan assembly. Disconnect the electrical connector from the fan and unbolt the fan from its mounting points. Finally, gently pull the fan out of the housing to complete the removal process.
what is a ac relay on a car ac relay switch turns the ac fan on and off depending on the temp of the freon too cold it turns off too warm it turns on depends on the preset temp
To replace a ceiling fan pull chain switch for a 3-speed fan, follow these steps: Turn off the power to the fan at the circuit breaker. Remove the fan's light kit or housing to access the switch. Disconnect the wires from the old switch. Remove the old switch and replace it with a new one. Connect the wires to the new switch according to the wiring diagram. Reassemble the fan and turn the power back on to test the new switch.