The air in the antifreeze on a 1993 Dodge Stealth will bleed out if you leave the coolant cap (the cap that screws onto the radiator hose connecting tube, NOT the antifreeze overflow plastic cap) off while the engine warms up. After the thermostat opens when the engine is warm, the antifreeze will start to flow from the engine, through the upper radiator hose, and into the top of the radiator. When you do not see bubbles at the filler neck where you removed the cap, the air should be expelled and you can put the cap back on.
i got it out from removing the air filter if ur talking about the reservoir
below the air intake on the throttle body
no the passenger air bag was introduced in 1994 changing the dash used from the gen 1 to the gen 2
the iat is built into the mass air flow sensor attached to the intake tube
the idc or idle air controller is located on the left of the engine under the throttle body
check and or clean air idle speed motor
MAS = mass airflow sensor, it measures the amount of air entering the intake plenum.
you have to take the air box out then if you look right under the intake youll see it it has two twelve mm bolts and a line just undo the line and then remove the bolts and reverse the procedure to install it
if its blowing, but not blowing cold its low on coolant. it takes r134a.
You take it out
remove the air intake to show the back side of head. the temp sensor in on the corner close to front of car on driver side. its next to the cam senor.
Check your radiator coolant level. On some cars, low coolant will let air bubbles into the heater core which can result in intermitant cold air bursts.