0
Funny I just got done doing mine... Remove the steering column shroud shroud (two Philips screws on the bottom)
Remove multi function switch screws on top (I believe it was a T20 torq head)
If you have tilt steering lower the column and lift the switch out your way.
On the left side is the ignition switch remove the singe screw with a T10 torqs with a whole in the middle
on the wire plug slide the red clip up and press down the clip
What else can I help you with?
How do you know if you need a ignition switch for Dodge Stratus 2000?
my brother has a 2001 stratus and had problems with the ingnition switch turning forward. we hired a lock smith to repair it at a fraction of the cost.
Where is the inertia switch on a 2000 dodge stratus?
There is none as your Dodge is not equipped with an inertia switch.
How do you replace headlight switch on 2000 dodge caravan?
To replace the headlight switch on a 2000 Dodge Caravan, start by disconnecting the negative battery cable to ensure safety. Next, remove the trim panel around the dashboard to access the switch. Disconnect the wiring harness from the old switch, then remove the switch by unscrewing it from the dashboard. Finally, install the new switch by reversing the steps, reconnecting the wiring, and securing the trim panel back in place.
Where is the dodge stratus 2000 fuel pump switch location?
A Dodge Stratus does not have a reset switch.
Where is the reset switch for a 2000 Dodge Intrepid?
No reset buttons on a Dodge.
How do you remove the door lock on 2000 dodge neon?
how to remove a door lock cylinder on 2000 dodge neon
Where is ignition switch of 2000 dodge ram 2500?
A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.
Inertia switch for 2000 Dodge Dakota?
Dodge does not use inertia/reset switches.
Where is the inertia switch on 2000 Dodge Intrepid?
Dodge doesn't use inertia switches.
Where is the inertia switch on a 2000 Dodge Grand Caravan?
Dodge does not use inertia switches.
Is there a kill switch on 2000 Dodge grand Caravan And where is it if so?
No kill switch on that van.
How do you change out the hazard switch in 2000 Malibu?
remove the trim around switch, remove screws that hold switch in, pull switch out, remove wire connector.
