answersLogoWhite

0

  • Clutches and Flywheels
  • Nissan Sentra
  • Nissan Stanza

How do you remove and replace the clutch on a 1993 Nissan Sentra?

User Avatar

Wiki User

βˆ™ 2015-07-15 19:38:22

Best Answer
Copy

start by removing the battery to have easier access to the transaxle then the intake and maf sensor together. Take out the clutch cable or the hydraulic slave depending on which one you have. Then take out all the connectors and sensors. Remove the starter. Then take out the speedometer cable. Then support the engine from up top if you have no way of supporting it proceed to take out the wheels and axles gear oil will be lost so have a pan ready. Then take out the center frame bar. Then support engine and start removing transmission mount and bellhousing bolts and remove trans. Remove pressure plate in criss cross pattern. Install in reverse. Pressure plate to flywheel torque specs are 16-22ft lbs

2015-07-15 19:38:22
This answer is:
πŸ€“
🀯
πŸ€”
User Avatar

Your Answer

Loading...

Related Questions

How do you replace door hinge bushings on a 1993 Nissan Sentra?

Have to remove the door, then remove pins and bushings


How do you remove the distributor cap and rotor on a 1994 Nissan Sentra?

how do you remove a distributor rotor on a 92 Nissan sentra


How do you remove a speed sensor on a 2008 Nissan sentra?

nissan sentra 2008 std


How do you remove a starter from a 1998 Nissan Sentra gxe?

can a starter be removed from the top on a 98 Nissan sentra gxe


Replacing a headlight bulb in a 1994 Nissan Sentra?

To replace the headlight bulb in a 1994 Nissan Sentra first prop the hood of the car. Locate the headlights and remove the bulbs from the housing. Install the new bulbs.


How to replace alternator on 1995 Nissan Sentra?

i found that there is only to bolts including the tensioner and do i need to remove the radiator hose


How do you remove Nissan Sentra headlight housing?

go to the dealer to do this


How do you remove a 1998 Nissan Sentra transmission?

To remove a 1998 Nissan Sentra Transmission, you first need to locate all of the bolts. From there, you will remove the bolts. Undo any wiring or tubing that goes into the transmission. From there, it can be taken out.


How do you remove the front door panel for a 2001 Nissan sentra?

How do you remove and install front door panel 1985 Nissan Sunny


How do you remove brake drums on a 1989 Nissan sentra?

very carefully :)


Where is water pump located on 97 Nissan Sentra and how to replace it?

The water pump on a 97 Nissan Sentra is behind the timing belt. To replace it you will need to drain the coolant, remove the cylinder head, loosen pulley bolts, drive belts, and water pump pulley. Next, remove coolant hoses, water pump bolts, and finally the old water pump. Reverse directions to replace with new pump.


How do you replace a clutch cable for a 1990 Nissan sentra?

# Remove the cover from under the facia panel # Release the nuts at the end of the cable at the release lever and disconnect the cable from the lever # Working from the inside of the car remove the clevis pin and disconnect the cable from the clutch pedal arm # Unscrew the two nuts which retain the cable grommet to the bulkhead and withdraw the cable from the car


How do you replace clutch switch on 2003 Nissan 350z?

Unplug your battery, pull off the connector, unscrew the bolt and remove the switch then replace and work backwards.


How do you replace a clutch in a 1995 s10?

Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.


How do you replace iat sensor 1998 Nissan Sentra?

disconnect the sensor from the wiring harness, removed the screw holding the sensor on, remove/replace and re-secure the screw and reconnect the wires.


What do you have to do to change a starter on a 2000 Nissan Sentra?

Simply locate the starter, and it's a remove and replace operation. A couple of bolts, a couple of wires and your back in business.


What size wrench to remove caliper from Nissan Sentra?

10mm or 3/8


How do you replace the egr temperature sensor for Nissan sentra?

Remove the wiring harness from the EGR temperature sensor. Remove the two retaining screws from the sensor. Reverse the process to install the new sensor.


How to remove the door panel on a 1989 Nissan Sentra?

take it to a strret raceing shop!


How do you remove a driver side mirror off a 1997 Nissan Sentra?

To remove the mirrors from you Nissan Sentra first remove the inside door panel. Pry the plastic mirror cover off of the mirror. Once this is done remove all of the nuts, bolts, or clips holding the mirror to the door.


How to to replace the alternator belt on a 1994 Nissan Sentra 1.6L?

BeltsYes, you must remove all of the belts to replace the alternator belt. The compressor belt first, then the power steering belt then the alternator belt.


How do you remove the rear bumper on a 2004 Nissan Sentra?

To remove the rear bumper on the 2005 Nissan Sentra, you will first need to remove the rear bumper cover by using a flat tool to pry the pins. Then, access the bolts holding the bumper to the frame of the vehicle and remove the nuts. The bumper will then lift off.


Where is the fuel pump relay on 1991 Nissan sentra?

The fuel pump relay on a 1991 Nissan Sentra is in the gas tank. To get to it you have to remove the back seat in the car and you will see a compartment that is at the top of the gas tank.


How do you remove the radiator support on a 2002 Nissan Sentra GXE?

I am replacing my radiator support in my 93 Nissan sentra SE-R this is the best i have found to do the job. i am using mig welder also to replace the welds. go to this link ---> http://www.goodwrench.com/gmgoodwrenchjsp/gmspo/Cadillac/Eldorado/1992-1999/02_Radiator_Support_Assembly.pdf


How do you remove the starter from 2001 Nissan Sentra SE 2.0 liter engine?

location on starter for 2001 sentra SE 2.0 liter engine