answersLogoWhite

0

start by removing the battery to have easier access to the transaxle then the intake and maf sensor together. Take out the clutch cable or the hydraulic slave depending on which one you have. Then take out all the connectors and sensors. Remove the starter. Then take out the speedometer cable. Then support the engine from up top if you have no way of supporting it proceed to take out the wheels and axles gear oil will be lost so have a pan ready. Then take out the center frame bar. Then support engine and start removing transmission mount and bellhousing bolts and remove trans. Remove pressure plate in criss cross pattern. Install in reverse. Pressure plate to flywheel torque specs are 16-22ft lbs

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

How do you replace door hinge bushings on a 1993 Nissan Sentra?

Have to remove the door, then remove pins and bushings


How do you remove the distributor cap and rotor on a 1994 Nissan Sentra?

how do you remove a distributor rotor on a 92 Nissan sentra


How do you remove a speed sensor on a 2008 Nissan sentra?

nissan sentra 2008 std


Replacing a headlight bulb in a 1994 Nissan Sentra?

To replace the headlight bulb in a 1994 Nissan Sentra first prop the hood of the car. Locate the headlights and remove the bulbs from the housing. Install the new bulbs.


How do you replace a clutch cable for a 1990 Nissan sentra?

# Remove the cover from under the facia panel # Release the nuts at the end of the cable at the release lever and disconnect the cable from the lever # Working from the inside of the car remove the clevis pin and disconnect the cable from the clutch pedal arm # Unscrew the two nuts which retain the cable grommet to the bulkhead and withdraw the cable from the car


How do you remove Nissan Sentra headlight housing?

go to the dealer to do this


How do you remove a 1998 Nissan Sentra transmission?

To remove a 1998 Nissan Sentra Transmission, you first need to locate all of the bolts. From there, you will remove the bolts. Undo any wiring or tubing that goes into the transmission. From there, it can be taken out.


How do you remove the clutch on a Nissan 200sx?

To remove the clutch on a Nissan 200SX, start by disconnecting the battery and lifting the vehicle for access. Remove the transmission by unbolting it from the engine, disconnecting any linkages, and supporting it with a jack. Once the transmission is out, unbolt the pressure plate from the flywheel, then take out the clutch disc. Finally, inspect the flywheel and replace or resurface it if necessary before installing the new clutch components.


How do you replace iat sensor 1998 Nissan Sentra?

disconnect the sensor from the wiring harness, removed the screw holding the sensor on, remove/replace and re-secure the screw and reconnect the wires.


How do you remove brake drums on a 1989 Nissan sentra?

very carefully :)


How do you replace clutch switch on 2003 Nissan 350z?

Unplug your battery, pull off the connector, unscrew the bolt and remove the switch then replace and work backwards.


Where is water pump located on 97 Nissan Sentra and how to replace it?

The water pump on a 97 Nissan Sentra is behind the timing belt. To replace it you will need to drain the coolant, remove the cylinder head, loosen pulley bolts, drive belts, and water pump pulley. Next, remove coolant hoses, water pump bolts, and finally the old water pump. Reverse directions to replace with new pump.