Cut the rubber seal and gently push the windscreen out.
To replace glow plugs on a Peugeot 405 turbo diesel, remove the connecting wire. Take off the 8 mm nut, followed by the 10 mm deep socket. Remove the old plugs and replace with new.
TNT
Remove the old wiper and replace with a new one
if petrol is about 10% or less fill with diesel and carry on. otherwise remove as much as possible and fill with diesel.
Remove the thermostat housing. where is, and how do i remove the housing
The tension of a drive belt on a Peugeot Partner Diesel Van can be determined by using a tension gauge, which can be used to measure and adjust the beltÃ?s tension. To replace the belt, open the hood, remove the screws to the air filter cover, and then remove the filter. Next you will need to remove the engine cover and begin to remove the starter. You will need to have the vehicle raised to gain access to the belt and may need to remove other parts to get a clear reach.
Remove backing plate on headlight unit.
If you want to change only the wipers, there are some clips over windscreen wipers. You have to lift up (with your hand) the wiper and un-clip, place the new and then clip again. If you want to remove the hole system you have: *to open the hood *at the beginning of wiper construction there is one big screw remove this with a key (it might stack, so you may hit it a little bit to unstack or use oil) Then you are done. You have removed the hole windscreen wiper system.
remove the radiator expansion tank (no need to remove water hoses ). pump is now easily removed by pulling straight up.
The thermostat on a 92 Pajero Diesel is on the left hand side and just above the pump. Remove the old thermostat and replace it with the same size.
To get to the pump: Remove front driver-side wheel Remove Wheel arch trim, normally only 3-4 plastic retainers and the pump is visible towards the front of the cavity Hope this helps 80)
You will have to buy a new bulb,then remove the old one and replace with new.