0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Remove anti tamper bolts on an air rifle?
Of over the 1000 different model air guns it would help if you listed the make and model.
How do you remove anti tamper bolt on hatsan 4410?
I suggest you contact HatsanUSA and ask for a parts drawing for your 4410. See the link below.
How do I remove a rusty old 1993 Ford f 250 front bumper and replace witha new one?
Spray some PB Blaster on the rusted bolts. Remove bolts and take bumper off. Install new bumper and new bolts. Used anti-seize on the bolts.
Can medicine tamper with pregnancy test?
No,anti biotics and or birthcontrol do not effect results of a pregnancy test.
What direction do you turn the bolt on the crankshaft pulley to remove it?
Most crankshaft pully bolts on European engines turn anti clockwise to undo them.
Remove MAF Sensor what type of screw is holding into place looks a star with a hole in the middle?
star = torx drive... and if it has a nub in the middle ( i didnt think cars had these) its a anti tamper type of screw..they sell torx with the nub out of the center
How do you remove seized rear caliper mounting bolts on a 2001 impala?
Take off caliper bracket and heat up bracket housing around mounting bolts until they turn. Pull out and regrease with anti- seize, my have to replace rubber sleeves.
How do you replace the brake pads on a 2000 Grand AM?
Remove the wheels, take out the bolts holding the calipers on, depress the pistons in the calipers all of the way and then remove the calipers. Be sure to use the anti-squeek shims and grease in the new pads
How do you get access to the rear bumper stop and fog lamps on a Shogun Pinin?
I now know! The back lights on the lower 'skirt' are covered by a plate. To remove - remove the three small bolts holding the mud-flap and plate and remove the plate. Access can now be gained to the back of the light cluster. Lamp holders are removed by turning anti-clockwise. Rusty bolts are your only problem!
How do you change front brake pads on a 2005 dodge ram 4X4 diesel?
Remove wheels, remove 2 caliper bolts per wheel, check bolts,and bushings for wear/corrosion and lubricate, remove calipers, remove brake pads, push caliper pistons into calipers, replace anti-rattle clips, put new pads in, put caliper and bolts in, put wheels on. Start truck and press brake pedal several times to take up slack and you're done.
How do you remove a valve cover on a 1996 Hyundai elantra?
CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Disconnect negative battery cable * Detach the accelerator cable from the cable guides on the valve cover (It's not necessary to remove the cable guides unless you're replacing the valve cover) * Disconnect the PCV and breather hoses from the valve cover * Remove the spark plug wire cover bolts remove the cover and then remove the spark plug wires * Remove the bolts that attach the upper timing belt cover to the valve cover * Remove the valve cover bolts and then remove the valve cover
How do you change the rear rotors on a 1998 Chevy Lumina?
Remove the 2 bolts from the caliper and then the 2 to the caliper bracket and just take off your rotor. Installation is in reverse of removal. Just make sure to put anti-seize on the bolts before putting them back in
