Want this question answered?
They are in the center of the Valve cover, under the plastic "chunks" that are the ignition coils. You might need to remove the plastic engine cover first. There are several plastic clips you need to turn part way to remove this part.
Remove the grill and the headlights will sort of hinge out so you can pop cover off back.
Remove the plastic cover on the outside and just pull the bulb out
It is under the plastic cover right below windshield. YOu have to remove retaining clips.
Had to remove the grill in my 96 XE
you need a headlight restoration go to a super center walmart with a tire and lube express it cost $40 for both headlights and they will do it your headlights will look brand new again
It is just clipped in. Just pull up - it will snapp off.
I need change the stop light in my Escape 2001 but I don't know remove the cover plastic
remove plastic cover that dohc 24 valves and that big black mess going from front to back of motor is the intake
Access from under the front corner of the car. Remove or push small plastic cover out of the way. Unplug bulb and rotate to remove.
You need to pop out the plastic cover over the nut in the armrest. Then use a 14 mm deep socket to remove the armrest. The job takes less than a minute.
You do not need to remove wiper arms to replace the filter. Pull the rubber cowl weatherstrip outward to remove on the passenger side about halfway across toward the drive side. Remove the cowl grilled cover, it has plastic fasteners that does not need tools to remove. Start be pulling the end of the panel gently upward enough to pop the plastic fasteners up so you can remove them by hand. Be careful when pulling on the plastic fasteners as they could be very sharp on the edges. There will be an old plastic air inlet cover under that cowl grilled cover. You can either remove the plastic fasteners like above or you can cut the plastic rosebud fasteners. Clean the area and you are ready to install the new filter.