Want this question answered?
To remove the back seat from a 1997 Honda Odyssey the seat locks need to be opened. When the clips are unlocked the seat will be able to be lifted up and removed from the vehicle.
Remove the bolts holding the seat on each side and then slide the seat back.
Loosen and remove the two Allen bolts at the rear end of the seat. Then, pull the seat back and upward.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
Remove the two Allen bolts at the rear end of the seat with a hex wrench, then slide it back.
Go to shhding.comProblem solved!
For about 10 bucks you can get a clip. go to shhding.com
Remove the Allen head bolt that fastens the passenger seat . Then lift this seat upward and pull it back to remove it. Next, find the two bolts that fasten the rider's seat at the rear. Remove them and lift the seat up and pull it back a bit.
A front passenger seat on a 2005 Honda Civic is held on by four bolts. Pull the seat back to loosen the front two. Pull the seat forward to reach the two rear bolts. Remove the seat.
I have a 2000 Honda VT1100 Shadow Spirit. I am not sure the 750's or later models have the same setup, but it is a place to start. "REMOVAL" Remove the rear seat bolt. (It is located at the rear of the back seat at it's base; centered, and more or less straight down from the backrest. Remove the rear seat by pulling it up, back, and then up and forward. Remove the front seat bolts. (there are two, centered at the back base of the now exposed front seat). Remove the front seat by pulling up and back.
Go to a junk yard and find a seat belt male connector for the Ridgeline and just leave the connecting latch attached.