the bottom of the seat just pops out. lift up on the front and pull. the top part you pull the release, then push it to the one saide then lift the other up and pull it out its that easy. no toosl are required
Probably NOT
remove the back plastic cover in the hatch and youll see the back of the bulb, unscrew and replace.
Remove the decorative cover to your 1997 VW tape player. Remove the tape player retaining screws. Remove the wiring harness from the back of the tape player.
just pop it off after you remove 2 screws the clips are good metal ones
After you open the back hatch, you notice two compartments, one on each side of the hatch area, remove the panels to gain access to the bulbs.
To remove the back seat from a 1997 Honda Odyssey the seat locks need to be opened. When the clips are unlocked the seat will be able to be lifted up and removed from the vehicle.
To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
Open the glove box, squeeze the sides in and remove the glove box (easy to re-install). Behind you will see a long horizontal rectangular hatch. Depress the plastic latch and remove the hatch. Remove old filter, clean out any loose debris, replace with new filter. Put the hatch and glove box back in and you are done.
Remove the decorative radio retaining plate. Remove the radio retaining screws. Remove the wiring harness, from the back of the radio.
A 1994 Mercury Villager, also known as a Dodge Caravan, can have its rear hatch removed by detaching the pistons which hold it to the body of the van. The pistons will be held by screws and removing them will allow the hatch to easily come off.
Make sure you have a friend support the back hatch while you take off the supports. They are bolted on. Do this because the hatch is quite heavy without the lifting arms.