pleasE advise. how do you remove the back seat of the Ls 430 2003? Also what TOOLS ARE REQUIRED?
how do you remove the back seat in the 2003 poniac grand am
Remove the cover from your 2003 Kia CD player. Remove the CD player retaining screws. Remove the wiring harness from the back of the CD player.
IT is located on top of the fuel tank to get there you have to remove the back seat which have 2 clips that pop out..
Open the trunk and remove the panel the runs across the back and remove the nuts and or bolts and disconnect the wiring plug and install the reverse order.
Remove the rear lower seat first by firmly lifftng up and then there will be 4 12mm bolts that hold the bottom of the upper rear seat back to the frame of the car. Then lift up towards roof and remove www.lextechautomotivellc.com
Remove the covers from your 2003 Chevrolet Avalanche speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers. Reverse the process to install the new speakers.
Remove the bolts holding the seat on each side and then slide the seat back.
Remove the retaining screws from the headlight assembly. Remove the wiring harness from the back of the headlight. The headlight will come out. Reverse the process to install the new headlight.
The first thing to do when replacing a cigarette lighter on a 1995 Lexus ES300 is to remove the fuse for this from the fuse box and disconnect the battery. Then remove the clip on the back of the lighter and slide the metal part out the front. Insert the new metal liner and connect the rear clip. Place the fuse back in the fuse box and reconnect the battery.
It is attached to the back wall of evaporator. You have to remove the glove compartment, blower unit and evaporator to get access to the expansion valve.
You must remove the plastic "buttons" holding the trunk lining (flathead screw driver). Remove enough to get lining out of the way to have access to the back of the tail light assembly.
front caliper two bolts on back of caliper one on top one on bottom remove both bolts an pull caliper up an off rotor that's all