Want this question answered?
hi there you have to take all the spline key srews out at window switches and bottom of door and down side panel and take wire for door open button
Start by pulling back the trim that holds the rubber boot for the mirrors to the bike. Under the boot you will find a screw that holds the front windshield trim, remove the screw, remove the trim and you will be able to see the mounting screws for the shield.
It will not take long at all to remove door trim from a Renault Menage. All you have to do is remove the bottom 10 mm bolts on the door, un-clip the door lights, undo the plastic trimming from the clips, unscrew the door cover and then remove all trimming.
Remove the inside boot trim and then pull away the metal clip holding it in. It can then just be pulled straight out from outside the car.
You can remove the outside trim by using a blow dryer or a heat gun to soften the adhesive underneath. Then you slowly work you way down. Then use laquer thinner or something like it to remove residue that is left. Hope this helps.
the paint colour code will be on a paper label stuck to the body of the car somewhere on my megane scenic it is stuck on the lock side of the door pilar at the base.be carefull which number you use it will also have the interior trim listed as a code on the same label and it doesn't say which is which.
Remove inner boot trim,locate solenoid pin,and pull back.
Remove the screws from the bottom of the trim and the one from inside the handle. The trip is mostly clipped onto the door and also has some foam stuck around the side as a seal
Lock stuck or cable broken. You will need to get into the boot space throught the back seat and remove as much trim as needed until you can see the lock then open it from there manually.
assuming it's an EB/ED GLi! if it's a globe problem. remove number plate, backing trim in boot. remove screws which holds entire external boot trim. globe plugs located on back of external boot trim. dumb idea ford EF/EL: Open the luggage compartment and remove the carpet around the back side of the boot - there are three fittings on the back of the lamp cluster assembly.... can't remember which is the reverse lamp one - usually bottom right (LHS assembly) or bottom left (RHS assembly). Remove those, twist old globe out - then reassembly is reverse of the above! Hope this expansion helps! In the EA/EB/ED you do not have to remove the numberplate, if you just open the boot and remove the backing panel the reverse light bulb holder just screws out. two screws in the backing panel and four pop clips!
you lift wiper blades up losen nuts ,might take bit off effort getting arms off,then remove screws holding the trim in place,remove trim ,u should see 2 maybe 3 bolts 10 mill i think,losen remove replace same as taken out
# Remove the center console # Detach the retaining screws from the center trim panel.Disconnect any electrical connectors and remove the trim panel