there are little clips that you will have to use a punch and hammer to knock them out. two of them.
How do i remove a heater core to a 1974 chevy impala?
It does not have a sensor, It has a switch and it is mounted just above the brake pedal.
To add brake fluid to a 1974 Chevy Nova, open the hood and locate the brake master cylinder, which is typically situated on the driver's side near the firewall. Remove the cap from the master cylinder reservoir and check the fluid level. If it's low, add the appropriate brake fluid (usually DOT 3 or DOT 4) until it reaches the recommended level, then securely replace the cap. Always check for leaks and ensure the fluid doesn’t become contaminated.
remove dist.cap.unplug wires and hoses mark rotor where it is pointing...remove holddown bolt remove dist.
On the rear brake calipers look for a hex nut just right at the back of the piston , unbolt it and with the Allen wrench turn right the inner pin carefully until the pads touch the disc and then move back 1/3 turn. and put the cover bolt and that's all. you have to do it in both calipers
A 1974 Chevy Impala frame would work
Answer auto repair manual 1974 454 maximum brake h.p 235 maximum torque lbs.ft.r.p.m. 36o@2800 @ 4000 nr.2.1974 454 maximum brake h.p 270 maximum torque lbs.ft.r.p.m. 380@2800@4400570 hp
YES.
I have a 1974 nova and my has 15 gallon
Normal people put headers on it, merely replacing the exhaust with "wider pipes" in laymans terms.. Or, for the economically disavantaged, remove the muffler.
Well, the engine in a 1974 vw Beetle is in the back of the car. So the brake fluid in front or the back to the left of the right.
the seats out of 73 to 88 Chevy or a gmc