pump the inside full of grease then find somthing solid that fits tight in the hole. line it up with the hole in the middle of the bearing and hit it with a hammer. you may have to fill it with gease and hit it a few times to get it out. the grease should push it out of the bore
the pilot bearing is on the crank center of the fly wheel, the smallest end of the transmission shaft will fit into it after it is assembled.
For Axle Nut its 30mm
Remove u-joint clip (CV Joint), remove as an assembly, press bearing out.
Raise the rear of the truck up and block up. Remove tires and brake drums. Drain rear differential by removing the cover. Remove the retaining bolt for the center pin in the cluster gears. Remove the center pin. Push axles inward, and remove c clip from cluster end of axle. Slide axle out. Remove seal. Remove circlip from wheel bearing. Remove bearing, a slide hammer style puller may be needed to remove bearing.
Monty - 1994 Pilot 1-0 was released on: USA: 1994
Gangbé Brass Band was created in 1994.
Wild West Showdown - 1994 Pilot 1-1 was released on: USA: 1994
how do you change rear wheel bearing in 1994 Plymouth acclaim
1)raise the car and remove the tire.2)remove the brake caliper.3)use a screwdriver to remove the hub dust cover.4)remove the cotter pin,adjusting cap,wheel bearing nut and washer.remove the outer wheel bearing.5)remove the hub and rotor assembly.
The Head - 1994 Pilot 1-1 was released on: USA: 13 August 1994
Tom - 1994 Pilot 1-1 was released on: USA: 2 March 1994
Hardball - 1994 Pilot 1-1 was released on: USA: 4 September 1994