0
What else can I help you with?
What size socket do you use to replace a wheel bearing on a 2006 cobalt?
you do not use a socket you use a wheel bearing puller to remove it from the hub Putting a right size socket into it and hitting it with a hammer can pop the bearing out, but it can also damage it so its advised to get the right tools. size 30 mm for the wheel nut and the bearing puller
Where is the diagnostics socket on your Toyota Corolla?
The diagnostics socket on a Toyota Corolla can be found inside the car. It is next to the hood release.
What size socket is needed to remove the rear hub bearing nut on a 2000 dodge stratus?
30mm
How do you remove the rotor on 1991 Ford F150 4X4?
special socket required to remove nut that retains rotor and wheel bearing. use impact gun . be prepared to repack and reset wheel bearing
How do you change rotors on a ford f 250 heavy duty pickup 4x4 5.8 liter?
Remove Wheels Remove center hub Probably spring loaded Remove gear (Should slide out) Remove spanner nut with spanner socket Remove brake caliper and support Wiggle rotor bearing should fall out Remove rotor
How can you get the right rear hub off a 91 Dodge Colt?
It is probably held on with the bearing retainer nut.Remove the nut, washers, and bearing, and it should come off.The bearing retainer, or "spindle" nut, usually requires a 30mm socket to remove. If you can borrow an impact wrench (an electric model works well), the procedure will be much easier.
What size socket for a Toyota Corolla spark pulg?
16mm
What size socket is required to remove the main nut from the end of your 89 Corsicas driveshafts?
It should be a 36mm socket.
How do you install front wheel bearings on 2001 Oldsmobile silhouette?
Remove tire, install spare which has an open center hole allowing access to axle nut, remove axle nut (33mm socket), remove spare, remove caliper, remove rotor, remove hub/bearing assembly, install new hub/bearing assembly, and so on in reverse order.
How to Remove a Corolla Headlight?
To remove a Corolla headlight, start by opening the hood and locating the headlight assembly. Remove any screws or clips securing the assembly, then gently pull the headlight out of its socket. Disconnect the wiring harness by pressing the release tab and pulling it away. Finally, replace the headlight bulb if needed and reassemble the headlight by reversing the steps.
How do you replace left front rotor 1992 F1504x4 cannot disassemble bearings to remove rotor?
to dissasemble wheel bearings you need a special socket after you remove 4x4 hub this special socket will only fit the front bearing nut .a different size is used on the rear
How do you replace a rear wheel bearing on a 2000 Chrysler neon?
It's simpler then it looks. Remove the wheel then the brake drum, with a flat head screw driver remove the dust cover. you will need a large socket to remove the nut. I bought one at Auto Zone I beliieve it was a 36MM but the package says earley Chrysler Front hub nut socket (same nut for the rear) after removing the nut the hub and bearing asy will slide off. When putting on the new hub make sure you grease it with bearing grease
