0
What else can I help you with?
Wheel bearings on 2000 Oldsmobile Silhouette?
Are a part of the hub assembly on the front Cost @ 400+ to repair one side! Rears are more like a traditional drum brake system type Haven't had to replace those
How do you troubleshoot front heater motor on a 1994 Oldsmobile silhouette?
Put a potato in the exhaust pipe.
Where is the low side port on a 2000 Oldsmobile silhouette?
it is on the passenger side at the front under the hood next to radiator
Where is coil pack on 1999 Oldsmobile silhouette?
standing at front of vehicle look straight to the back top of motor,
Can just the front wheel bearing be replaced instead of entire assembly on 2000 Oldsmobile intrigue?
The front wheel bearings and hub come as one piece. The bearings alone are not serviceable.
How do you install wheel bearings on delta 88 1966?
Back or front?
How do you install a 1997 BMW E36 Wheel bearing?
the front wheels have no bearings
What is the firing order on a 3.4 Oldsmobile silhouette?
The firing order is 1,2,3,4,5,6. Front cylinders are 2,4,6 the rear 1,3,5 from left to right as you face the engine from the front.
How do you install front wheel bearings on a 2001 Ford Focus?
How do you replace front wheel bearing on a ford focus
Where is the starter located on a 2001 Oldsmobile silhouette?
At the bottom front. Once you remove the plastic front air dam it's easy to access. Keep in mind that it's small.
How do you replace the Front brake pads 1999 Oldsmobile silhouette?
To replace the front brake pads on a 1999 Oldsmobile Silhouette, first, lift the vehicle and remove the front wheels. Next, remove the caliper bolts, then carefully slide the caliper off the rotor and support it to avoid straining the brake line. Remove the old brake pads from the caliper bracket, compress the caliper piston using a brake tool, then install the new pads and reassemble the caliper. Finally, reattach the wheel, lower the vehicle, and pump the brake pedal to ensure proper brake engagement.
Can you explain a wet front floor on a 1996 Oldsmobile Silhouette not clogged AC drain and not bad heater core?
It is quite possible that a wet floor on a 1996 Oldsmobile Silhouette is caused by a leak in the body that allowed rain water to get into the passenger area. Window seals and the seals around the front firewall could have been damaged enough for this to happen.
