0
What else can I help you with?
How do you replace wheel bearings in a 2001 Oldsmobile Intrigue?
To replace the wheel bearings in a 2001 Oldsmobile Intrigue, start by safely lifting the vehicle and removing the wheel. Next, detach the brake caliper and rotor to access the hub assembly. Remove the hub assembly by unbolting it and carefully pulling it off the spindle. Finally, install the new wheel bearing by reversing the process, ensuring everything is torqued to spec and properly aligned.
Why is the traction off light service vehicle light and brake light on always in a 1999 Oldsmobile Intrigue?
Usually caused by a bad ABS sensor or wiring harness to the sensor. Both are serviced with a hub-bearing assembly.
How do you repair a 99 Silverado front wheel bearing that is bad?
The front wheel bearing assembly is not repairable. A new wheel bearing assembly is replaced as a complete unit. Your local auto parts store can supply you with a new bearing assembly.
How do you change the front wheel bearing on a suzuki xl7?
THE BEARING ASSEMBLY IS NOT REMOVABLE FROM the hub. It's replaced as a unit.
What makes a humming or growling sound when driving 2000 intrigue over 20 mph?
Wheel bearing/hub assembly
How do you lubricate 2004 monterey wheel bearings?
You can't. They are not serviceable. They are replaced as a hub/bearing assembly.
How do you change the wheel bolts on a Oldsmobile regency 98?
you have to replace the wheel bearing hub assembly look up a picture and you will see the bolts are attached to the hub assembly.
How do you remove the bearing seal on the front rotor of a 2003 Chevrolet S10?
If this S10 is a 4+4, the seal and bearing is not serviceable. The hub and bearing assembly is replaced as one unit.
Where is a Speed sensors located in a 2001 grand am?
The speed sensor is located inside the Wheel Bearing Assembly, and cannot be replaced separate from the Wheel Bearing Assy.
How much is fixing a Pontiac grand prix se bearing?
I replaced a front wheel bearing on a 1998 GP for about $500 at a dealership. That was about 5 years ago. It's a big job to do yourself, even with air tools. The bearing is an assembly that is replaced as a unit.
You replaced the tensioner pulley and bearing assembly on a 3.0 2000 ford ranger after replaceing the pulley assembly it still has wobble Is there a spacer that fits between the shaft and bearing?
check you motor mounts and trans alignment your pulley shouldn't wobble with a new assembly
What is humming on the driver side of a 2001 Chevy Malibu?
probably the wheelbearing in the hub assembly not replaceable on its own hub,bearing and abs sensor one integrated assembly and must be replaced as such
