0
What else can I help you with?
What kind of wrench is needed to remove the front caliper bolts on a 2005 dodge stratus?
7mm hex socket
How do you change the front wheel bearings on a 1998 Dodge Stratus?
I posted this question and have since replaced the bearings. Since an answer was not posted I will answer it myself. It's not too difficult. You need a 32mm Socket to remove the retaining nut. An inverted star socket(similar to a reverse torx wrench)is needed to remove the bolts holding the bearings in place(I think it takes a #16 inverted star bit). You also need a hub puller to remove the bearing assembly from the drive shaft. Good Luck!
How do you remove a cigarette lighter socket in 2006 dodge stratus?
To remove the cigarette lighter socket in a 2006 Dodge Stratus, first, disconnect the negative battery cable to ensure safety. Then, use a flathead screwdriver to carefully pry off the trim surrounding the lighter. After removing the trim, you can access the socket and disconnect the wiring harness attached to it. Finally, unscrew the socket from its mounting and pull it out.
What size Allen socket is needed to remove caliper bolt on a 2004 Escape?
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
What size socket do you use to replace a wheel bearing on a 2006 cobalt?
you do not use a socket you use a wheel bearing puller to remove it from the hub Putting a right size socket into it and hitting it with a hammer can pop the bearing out, but it can also damage it so its advised to get the right tools. size 30 mm for the wheel nut and the bearing puller
What size Allen socket needed to remove brake calipers?
9mm
How do you remove the rotor on 1991 Ford F150 4X4?
special socket required to remove nut that retains rotor and wheel bearing. use impact gun . be prepared to repack and reset wheel bearing
What size socket is needed to remove spark plug on a 2002 Hyundai Accent?
You will need a 5/8 socket.
What socket size is needed to remove the front hub nut from a Peugeot 306?
You will need a 35 mm socket.
What size socket should be used to remove a 1994 corolla front hub bearing?
For Axle Nut its 30mm
What kind of wrench is needed to remove the front caliper bolts on a dodge stratus?
I used a 7mm hex bit socket. Worked fine, but the tool was a little hard to find. the 7mm hex key does not typically come in a L-key set.
What size socket is needed to remove spark plug on a 97 Hyundai accent?
You'll need a 5/8" socket.
