0
What socket size is needed to remove the front hub nut from a Peugeot 306?
Wiki User
∙ 8y ago
You will need a 35 mm socket.
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
What socket is needed for the front axle nut for the hub assembly on a 1984 Chevy pickup?
A 11/16 socket is needed to remove the 1984 Chevrolet pickup front axle hub assembly. The socket should be a five-point socket.
What kind of wrench is needed to remove the front caliper bolts on a 2005 dodge stratus?
7mm hex socket
Where is the fuse for the front 12v socket in a peugeot 307 hdi?
Fuse #7, down right.;)
What size wrench is needed to remove the caliper bolts on the front brakes of a 99 Pontiac sunfire?
You need a 3/8" allan key or hex socket - not a torx
How do you remove front grill peugeot 207?
Why buy the car if you want to take out the grill.
What size socket for a peugeot partner hub nut?
35mm on the front, some people use a 6 sided 36mm without problems
How do you unclip a rear seat in a 1993 civic?
Remove the bolt in the back middle of the seat-- 10mm socket will be needed,with a extenition, donot try to remove the fingers in the front of the seat before removing the 10 mm bolt -- a six sided 10 mm socket will work the best. billy
Where is the oil filter situated on a Peugeot 207 GTI engine?
you will need to remove part of the air intake pipe to see the filter housing, its under the air intake pipe that comes from the front grille, you will need a 27mm socket to change the filter.
How do you change the front lights on a peugeot 106?
you haft to remove the bumper first to get to the bolts holding in the lights
What size socket to remove axle nut on front gmc sierra 4x4?
36mm
How do you replace the front turn signal bulb located on a 1997 Pontiac Sunfire GT?
Remove the front inner wheel well splash shield. Grasp the bulb socket and rotate it counter-clockwise to remove it from the lamp. Remove the bulb from the socket. Installation is the reverse of removal.
What size Allen socket is needed to remove caliper bolt on a 2005 Expedition?
Try a TORX T-40 or 45 Many second generation Expeditions (2003-2006) use a 9mm to remove the front caliper and a 7mm for the rear.
