0
What else can I help you with?
What size socket is needed to remove spark plug on a 97 Hyundai accent?
You'll need a 5/8" socket.
How do you replace a cigarette lighter socket on a 2005 Hyundai accent?
To replace the cigarette lighter socket on a 2005 Hyundai Accent, first, disconnect the negative battery terminal to ensure safety. Remove the dashboard trim surrounding the socket by gently prying it off, then unscrew and disconnect the old socket from its wiring harness. Install the new socket by connecting the wiring and securing it in place, then reattach the trim and reconnect the battery. Test the new socket to ensure it functions properly.
Where is the ecu on a 2002 Hyundai accent?
where is the ecu for a 2002 Hyundai Accent?: this computer is located under the dash, left side. can't miss it, just look under the dash. bolted in with 6mm bolts, use 10mm socket to remove. Make sure you disconnect battery first if you decide to remove it or replace it.!
How do you remove the back seat of a 1996 Hyundai accent?
for Hyundai accent gsi (yr 2000) needed: 12mm short socket ratchet remove spare tire cover. Fold down rear seats. Remove the bolt holding each seat separately onto hinge. remove these two pieces. Remove the two bolts from each side from the rear of bottom seat section. From the front of the rear seat there are two buttons-levers-mini handles.. push those towards the rear of the car and pull up on seat cushion.
How do you remove the front seats of a 2012 Hyundai accent?
To remove the front seats of a 2012 Hyundai Accent, start by disconnecting the negative battery terminal to prevent any electrical issues. Next, slide the seat all the way forward to access the rear bolts, and use a socket wrench to remove them. Then, slide the seat back to access the front bolts and remove them as well. Finally, carefully disconnect any wiring harnesses attached to the seat, and lift the seat out of the vehicle.
How do you remove rear seat cushion on 2007 Hyundai accent?
To remove the rear seat cushion on a 2007 Hyundai Accent, first, locate the seat cushion release clips or bolts at the front edge of the cushion. Pull up on the cushion to disengage it from the clips or remove the bolts with a socket wrench. Once detached, lift the cushion upward and pull it out from the vehicle. Make sure to check for any wiring or additional fasteners before completely removing it.
How do you change parking lights 2003 Hyundai Accent?
To change the parking lights on a 2003 Hyundai Accent, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly, then gently pull it out. Disconnect the wiring harness and twist the parking light bulb socket counterclockwise to remove it. Replace the old bulb with a new one, reassemble the components, and test the lights to ensure they work.
How to remove an oxygen sensor from the exhaust manifold on a 2001 accent?
by unplugging the sensor from the contact and using a slotted socket to remove it. This socket usually is bought separate from a set.
How t remove engine cover on a Hyundai Accent 2012 to check spark plugs?
To remove the engine cover on a 2012 Hyundai Accent, first, locate and remove the screws or bolts securing the cover, typically found along the perimeter. Use a socket wrench or screwdriver, depending on the fasteners used. Once the screws or bolts are removed, gently lift the cover off, being cautious of any clips or tabs. With the cover removed, you can access the spark plugs for inspection or replacement.
What size socket do you require to remove cylinder head bolts on a Hyundai coupe v6?
10mm
What size socket do you need to remove the axle nut from a 2003 Hyundai sonata?
32mm Hex
What size Allen socket is needed to remove caliper bolt on a 2004 Escape?
What size Allen socket is needed to remove bolt from caliper on 2004 ford escape
