To remove the calipers on a 1990 Cutlass Ciera, first, ensure the vehicle is securely lifted and supported. Remove the wheel to access the caliper, then detach the caliper by removing the bolts that secure it to the bracket. Carefully slide the caliper off the brake rotor and support it with a wire or bungee cord to avoid straining the brake line. Finally, disconnect the brake line from the caliper if necessary.
Any other GM A-body should work (82-96 Buick Century, Olds Cutlass Ciera, Pontiac 6000)
It is quite easy to change the thermostat in your 1990 Cutlass. Remove the thermostat housing retaining bolts. Remove the thermostat from the housing. Reverse the process to install the new thermostat.
no it has dic brakes
GLove box
Around 3,000 lbs
yes, most of the panels can be used from one to the other
FRONT OR REAR ?
i think it is on the trunk lid above the plate.
To disconnect the antenna power on a 1990 Cutlass Ciera, first, locate the antenna assembly, which is usually found at the rear of the vehicle. Remove any trim panels if necessary to access the wiring. Then, disconnect the power wire from the antenna motor, typically a small connector or plug, ensuring the ignition is off before handling. Finally, if you need to remove the antenna, unscrew it from its base and pull it out gently.
if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...
Remove the RH lower dashboard sound insulator and the glove compartment. Look for a shiny metal box about the size of an old GM ECM.
I've got an 89 cutlass ciera and it is located behind glove box. open and pull out like 4 screws and there it is.