i think it is on the trunk lid above the plate.
Look under hood against firewall - should be a plate with paint codes
The throttle position sensor (TPS) on a 1989 Oldsmobile Cutlass Ciera with a 2.8L engine is typically located on the throttle body, which is mounted on the intake manifold. It is positioned near the throttle plate and connected to the throttle linkage. You can identify it by its electrical connector and the fact that it rotates with the throttle plate as you accelerate.
Possibly a bad ground in the rear wiring harness somewhere.
Will they fit?If the 88 strut is the same as the 89, then the answer is NO. 20" rims will fit the rear but not the front due to the clearance of the lower strut plate. Not with out some cutting and grinding. Actually they will i have a 1994 Oldsmobile Cutlass Ciera S and i have two sets of rims on them 18's and 20's.All you have to do is find the right width of the rim and size of the tire.(ps my first set is 18' by 7.5 and tire size 225/40.The second set is 20' by 7.5 225/30)
there should be a either 1 or 2 little plastic covers on the side of or above the plate, turn these about a quarter turn then they should pull out inside that you will see the bulb most just pull straight out, install new bulbs and put covers back in place. good luck
Of COURSE :-)
to wire the license plate lights you must have lights and wire them to the scooter.
under the back license plate
No, the license plate light is wired in with the rear tail lights, not the brake lights.
The tail lights and plate lights are on the same fuse, if the tail light come on it is not the fuse. Plate lights are not checked that often and it is common for them both to be brunt out when they are noticed.
the fuse should be labelled tail lights.(whats the problem with no. plate lights?)
The license plate lights are not in a separate fuce by it seft. They are the same as your side marker lights. So, check if your side marker lights are working and if they are them is a bad license plate light bulb.