there should be a either 1 or 2 little plastic covers on the side of or above the plate, turn these about a quarter turn then they should pull out inside that you will see the bulb most just pull straight out, install new bulbs and put covers back in place. good luck
i think it is on the trunk lid above the plate.
under the back license plate
Look under hood against firewall - should be a plate with paint codes
The throttle position sensor (TPS) on a 1989 Oldsmobile Cutlass Ciera with a 2.8L engine is typically located on the throttle body, which is mounted on the intake manifold. It is positioned near the throttle plate and connected to the throttle linkage. You can identify it by its electrical connector and the fact that it rotates with the throttle plate as you accelerate.
How do you change the lamp on the license plate of a lincoln ls 2000?
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
how do you change the light bulb over the license plate on 2000 eclipse
No. The licence plate cannot be altered.
how to change 2005 equinox license plate light i removed the screws but it didn't release
How do I change the license plate bulb on a 1993 Lexus ES 300
how do you change the rear license plate light on a 1999 Buick Regal
No there will be additional charge for getting your license plate changed