0
to wire the license plate lights you must have lights and wire them to the scooter.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where do you find power for license plate lights?
A license plate light is put on almost every car. The power wire is probably already there. Look close for a loose or unplugged looking wire around your license plate area. If you have no wire you'll have to run one and tie into a running light in one of your tail lights. Hope that helps.
How do you hook up license plate light on a 1990 Chevy truck?
That truck came equipped with a license plate light, so there should be a wire present for that function. Look for a disconnected wire behind the rear bumper. The wire would be live when the head lights are on. Connect a new light and make sure it is properly grounded.
How do you wire the light that illuminates the license plate on a 99 F250?
I would look for the coloured wire that was attached before. Is it broken off? is there a bit left attached to the light? if not you could look at a wiring schematic. Not likely to happen, look at the coloured wire going to one of the running lights in one of your tail lights. Tap into that and when your running lights are on the licence plate light should come on as well.
How do you wire a license plate light on a 91 Toyota truck?
Easiest way is to connect a single wire from one of your rear taillights "parking light" to the wire on license plate light. It gets its ground from the bumper once installed.
Why doesn't my tail lights and license plate lights do not work on my 1998 Lincoln town car?
First check all your fuses. If they are good, then check for voltage from the headlight switch. If you have that, then the Light Control Module is bad. There is a brown wire coming from that module that controls the tail lights, licence plate lights, and running lights. You can also check by applying 12 volts to the brown wire and ground. If your lights come on, then for sure it is the light control module located under the dash by the steering column.
How do you locate and identify the fuse for the license plate light for a 2004 Chevy Impala 4d v6 3.4liter engine?
I think for most cars, the license plate lamp is on the same fuse as the taillights, so if the taillights are working, and the license plate lamp isn't, check the globe or the wire
1995 subaru impreza license plate light and tail lights stay on can i fix it?
You need to either wire a jumper to a tail light or use an ice cube relay and wire it to the switch side of it with the trigger being the headlight switch and the bulb should go to ground on the other side
Why is my Lexus license plate light intermittant?
The license plate light on a Lexus may turn on and off if there is a loose wire. Try wiggling the wires around and see if the light goes on and off. If it's not a loose wire then the light bulb may have come loose and needs to be tightened.
All bulbs and fuses on 1998 Chevy cavalier are good. The signals hazards brake lights and back up lights work. The tail lights and licence plate light do not work?
that points to a broken wire to the light, a bd ground wire or a bad light switch
1989 Plymouth Reliant tail lights and license plate light wont work checked wiring bulbs and fuses?
had 1987 dodge Aries with same thing wrong, its was bad ground wire just ran new ground wire from rear harness to a screw I put in rear metal tail panel it worked.
What can cause the license plate bulb not to work on a 1995 ford escort?
there is a bad ground ,or the wire going to the bulb is open or the bulb is burned out.
How do you replace the license plate light on a 2002 Hyundai elantra?
On my 2000 Hyundai Elantra, you can access the license plate lights from the outside. You use a flathead to pop out the right side of the light, twist the back end (where the wire comes out) and the part with the bulb comes out. Pull it out, slide the new bulb in, retwist it into its container and pop the light back in place. Repeat for other side. Cost me $3 for the bulbs and took me about 5 min to do.
