Pull straight out, they are friction knobs with flat sides, just like the poles the slide onto.
I need info on how to remove the climate control unit from my 1998 corvette.
The fuse box is located under glove compartment. However, if there is desire to access the bulb and fuse on the climate controller, twist and remove the knob and it should be connected at the back.
http://www.justforjeeps.com/tjwrachecokn.html
how to remove the knob of the windshield wiper control there is a slot at the end of the knob close to the dash.Use an angled pliers or bend a wire or paper clip and insert it between the knob and rod towards you to loosen it
On my 2002 X-Type I PUSH the fan knob/rheostat. This cycles the climate control/AC on and off. Hope this helps a bit.
It is a button with a graphic of a rectangle with 3 squiggly vertical lines that cross the bottom line of that rectangle. It is located in the center section of the climate control area, which is below the radio, between the fan speed knob abd the diverter knob. If you have automatic climate control, it is above and to the right of the digital display. If you do not have automatic climte control, it is below and to the right of the temperature knob.
To replace the 1996 V6 Mercury Sable climate control and take out the old control, you will need to remove the covering below the steering wheel and dashboard. Then, access the climate control in the instrument panel and remove the old control.
There is one bulb for the manual heater control. It is located behind the fan control knob. Remove the knob take a piece of vacuum or windshield washer hose and remove the bulb. Install in reverse order of removal. The bulb is a 194 bulb.
To remove the gear shift knob on the SLK 320, first pry the cover from the gear shift knob. Then, use a screwdriver to remove the screw in the center of the knob. This will then allow the knob to be removed.
how do i remove Chevy aveo 2006 shifter knob
yes get to tools to remove the radio and it will remove the climate control panel. i used a wire hanger and snip it into 2 pieces bent them to shape and it works just fine.