Pull straight out, they are friction knobs with flat sides, just like the poles the slide onto.
http://www.justforjeeps.com/tjwrachecokn.html
To remove a climate control knob, start by gently prying off the knob using a flathead screwdriver or a trim removal tool, being careful not to damage the dashboard. If the knob is secured with a set screw, locate it (usually at the back or underside of the knob) and use an appropriate screwdriver or Allen wrench to loosen it. Once any screws are removed, pull the knob straight off the shaft. Always consult your vehicle's manual for specific instructions related to your model.
On top of the switch there is a button, press down. Pull knob off.
Loosen the Jam nut on the bottom of the know CW and then turn the knob CCW..
To remove the shifter knob on a 2007 Jeep Wrangler, first, place the vehicle in neutral or park. Locate the small rubber cover at the base of the knob and gently pry it off to expose the retaining screw. Use a screwdriver to loosen and remove the screw, then pull the shifter knob straight up to detach it from the shifter shaft. Be careful not to damage any surrounding components during the process.
The fuse box is located under glove compartment. However, if there is desire to access the bulb and fuse on the climate controller, twist and remove the knob and it should be connected at the back.
Yes, the climate control unit in your Mazda 3 can often be repaired if the temperature knob is not responding. First, check for any loose connections or blown fuses related to the climate control system. If those are fine, the issue may be with the knob itself or the climate control module, which may require replacement. Consulting a professional mechanic or Mazda dealership for diagnostics and repairs is recommended for accurate troubleshooting.
how to remove the knob of the windshield wiper control there is a slot at the end of the knob close to the dash.Use an angled pliers or bend a wire or paper clip and insert it between the knob and rod towards you to loosen it
On my 2002 X-Type I PUSH the fan knob/rheostat. This cycles the climate control/AC on and off. Hope this helps a bit.
It is a button with a graphic of a rectangle with 3 squiggly vertical lines that cross the bottom line of that rectangle. It is located in the center section of the climate control area, which is below the radio, between the fan speed knob abd the diverter knob. If you have automatic climate control, it is above and to the right of the digital display. If you do not have automatic climte control, it is below and to the right of the temperature knob.
To change the climate control from Fahrenheit to Celsius on a 1992 Ford Thunderbird, locate the temperature control knob on the climate control panel. Press and hold the "Temperature" button while simultaneously turning the knob to adjust the temperature setting. After a few seconds, the display should switch from Fahrenheit to Celsius. If your model does not have this feature, it may not be possible to change the unit of measurement.
There is a small button on the back of the switch you need to hold down while pulling out the shaft and the attached knob. Then, you can remove the slotted nut freeing the switch.