If it is one of the main side brake lights, open the tail gate, remove the two Philips screws from the side of the lense, and slide the entire light assembly towrds you to remove it from the body. If it is the 3rd brake light in the tail gate, pry the edge facing you up slightly, then pull the cover towrds you to remove it and you will have access to all three bulbs in it.
The lens assembly is held in with two screws. Remove those and the lens will pop out.
How do you remove the brake light cover on a ford focus
how do you remove the brake light cover on a 1991 gmc tracker? Do you go from the outside or inside?
How do you remove cover to replace brake light on 57 kia Rio
Pull back the rug and insulation.
Jack up the Concord. Remove the wheel. Unbolt the brake caliper and swing it out of the way. Remove the dust cover for the axle nut. Remove the nut and slide the hub off. Replace the bearings and reinstall.
Chrysler dealer
Remove the map light retaining ring. Remove the map light cover. Take hold of the lightbulb, push in and turn at the same time. The lightbulb will come out.
To remove the axle shaft, first remove the wheel, and brake drum/rotor. Second, remove the differental cover. Third, remove the bolt holding the spider gear shaft, and remove that shaft. Fourth push inward on the axle shaft to remove the horseshoe clip on the inside. The axle shaft will now pull out.
You have to remove the hub,
Remove the oil fill cap located on the valve cover or near the valve cover. Do not overfill.
It is in the center of the rear valve cover.