you need a special tool to release a clip behind the handle any body shop guy could help ya out.
front of the engine under the crankshaft pulley
on the crank behind the drive pulley and harmonic balancer
Remove the fuel tank. Mounted inside on the top of the tank.
how do i remove the passenger door inside panel?
Raise the left front of the van then remove the wheel and the rubber splash shield. Remove the drive belt and the bolt that retains the pulley to the crankshaft next use a puller to remove the pulley. On installing it you need an installer don't hammer on it, I have seen that done and the crank destroyed. Depending on your location parts stores will loan or rent the puller and installer.
Requires removal of: Fan shroud, serpentine belt, fan, water pump, timing cover, crank pulley(s). Requires crank pulley puller/installer tools. Requires timing gear puller to remove crank gear. Replace chain and gears together. Replace with all-metal gears, not composite sets. On this vehicle it is recommended to replace the timing cover each time it is removed.
The pulley that actually makes the belt move is the crank shaft pulley. It's usually the largest one at the bottom center of the engine's front.
The crank position sensor On your astro is located on front of the engine on timing cover, left side. Behind the crankshaft pulley. with a connector of 3 wires.
There are none. The cam needs to be set with a plate and use pins to set the crank and fuel pump pulley.
replace a windshield wiper switch on a 1995 chevy lumina van
Check to make sure there is power going to your coils from your ignition switch.