# Lock the CD changer unit mechanism (if so equipped) prior to removing a malfunctioning CD changer unit. Refer to "LOCKING CD CHANGER UNIT MECHANISM". # Remove upper cluster lid C by firmly grasping and carefully pulling rearward from instrument panel. # Disconnect hazard switch connector. # Remove lower cluster lid C by firmly grasping and carefully pulling rearward from instrument panel.
# Remove six screws and remove audio unit and storage bin/CD changer as an assembly. # Disconnect audio unit connectors.
CAUTION: Do not pry or forcibly remove heater A/C control bezel from audio unit face plate or audio unit damage could result.
# Release two tabs using a screwdriver and carefully remove heater A/C control bezel from audio unit face plate. # Remove brackets from audio unit and remove audio unit.
color codes for wiring on factory stereo on 2008 Nissan sentra?
WHAT YOU HAVE TO D IS REMOVE WITH A SCREW DRIVER THE LITTLE COVER BETWEN THE SWITCHES FRO THE EMERGENCY LIGTHS AND THE DEFROSTER UNDER THIS COVER IS A LITTLE SCREW REMOVETHAT SCREW AND JUS PULL THE TRIM THEN YOU JUST HAVE TO REMOVE THE SCREWS THAT ARE HOLDING THE STEREO IS REALLY SIMPLE
Remove the retaining cover from your factory stereo. Remove the factory stereo retaining bolts. Slide the factory stereo out. Remove the wiring harness and the antenna cable from the back of the factory stereo.
Remove the 2002 Dodge Durango factory stereo decorative cover. Remove the factory stereo retaining screws. Pull the factory stereo out. Remove the wiring harness and the antenna cable from the back of the stereo.
How do you remove stereo from 2000 nissan pathfinder?
no you do not. not even if you have the rockford fosgate package. you just wire up the aftermarket harness(95+ nissan) make sure you connect the blue/white wire. that will turn on the factory amp.
How to remove factory stereo from 2001 honda civic?
go to0 a stereo shop and buy one and have it installed go to0 a stereo shop and buy one and have it installed
you have to remove the front console. take out the ash trey. and remove all the screws around the trim of the area of the stereo and then slid the stereo out and un hook all connections. if you get a new stereo it should have more detailed instructions
the acutually dash removal of the Comfort-Control Toggle Switch in order to remove facing for radio replacment of 1990 nissan maxima?
The stock stereo, from a 2003 Nissan Altima, can be removed by first removing the stereo front cover. Next, remove the four screws. Pull the stereo out and remove the wiring.
whats the wiring color codes for my 98 sentra radio
Try the fuse box
To remove the factory stereo on 1996 dodge ram 1500 you need to pop the hood on the Ram and remove the ashtray. Slide the stereo out of the dash and unplug the cables from the back of the stereo.
Remove the decorative stereo retaining cover. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness and the antenna cable.
The 2002 Nissan Pulsar Factory Stereo wiring diagram can be found in the maintenance manual. It can also be found in the cars repair manual.
When making any electrical changes to the wiring of a car, it is important to have a diagram. A diagram for the factory stereo wiring of a 1993 Nissan Pathfinder can be found in the maintenance manual.
There is no way possible to remove the stereo and replace it with an aftermarket stereo. I have talked to 15 Nissan Dealers and Nissan head technical office. They all state that it can not be done. --+Skifo How Much
send this question next week I will be replacing the stock stereo this weekend if weather permits
You need to remove the wiring harness of the stereo and pull it out. It is fairly easy to replace this with something more advanced.
Use the clock on the aftermarket stereo that you should buy. My clock on my 92 always gets off so i just use the clock on my stereo.
use your hands Xd
Watch the following video. It give a clear step-by-step overview of the process. http://www.youtube.com/watch?v=hlp2KuWpoFI