Carefully pry it off with a broad bladed screw driver or similar tool.
It is really simple. All you have to do is remove the plastic cover for the map light and the bulb is right there. If you put a screwdrive in the middle side fo the clear cover you can pry the cover off and have access to the light. The cover is made to be removed this way so don't use excessive pressure or you might break it.
you take out the old light and put the new one in
Look in the trunk, there is a cover over the light assembly - open and you will have access to change the light.
You will need to access a diagnostic computer to turn off the check engine light on the 2003 Honda Accord. You could also remove the fuse from the dash lights or instrument panel.
how do i remove my cd form my crv honda 2003
To remove the rear interior light on a 2003 VW Passat wagon, first, use a flathead screwdriver to gently pry off the light cover. Once the cover is removed, unscrew the retaining screws holding the light assembly in place. Disconnect the wiring harness from the light assembly, and then you can fully remove it from the ceiling. Finally, reverse the process for reinstallation.
With a straight screw driver. flip the round upper and lower cover, then use a small Phillips to remove the screws. Pry/lift the cover off, then lightly push in and turn the bulb counter clockwise
it should just be a velcro cover. now if it is the whole taillight then u have to go through ur bed cover and do it that way.
There is a plastic cover in front of the engine. Under the cover is the intake manifold. After you have removed the plastic cover, then the intake manifold you will see the starter. Before you can remove the starter you will need to remove wires tubes and linkages. It will take a few hours if you are good.
Disconnect the battery supply. Remove the inside driver side dashboard under cover. Remove the actuator and screws. Reverse to install.............
Remove the air cleaner housing cover. The air filter will lift out. Set the new air filter in the housing and replace the cover to its original position.
Just open the back hatch of the vehicle. When you do that, you will see two screws holding the brake light cover to the vehicle. Take them off, then separate the cover from the vehicle. This will gain you access to the lights.