DRLs are activated through fuse 13 (10 amp size) in your fuse housing inside your engine bay. Removing this will deactivate your DRLs. Just be sure to reinstall it if you have an insurance claim (as most insurance companies will give you a discount for DRLs, but will remove your discount if they find the feature disabled).
The DRL is controlled by fuse 13, 10 amp size, located in the fuse block located inside your engine bay. Removing this fuse will deactivate your DRLs. If you get into an accident and file a claim, be sure to reinstall this fuse, as most insurance companies give you a discount for having DRLs but will penalize you if they find out you disabled it.
How to disable the DRLs depends on the specific make, model, and year of vehicle you're working on. In some cases it's easy, in some cases it's almost impossible without causing problems. The preponderance of evidence is that DRLs, thoughtfully implemented, do reduce your risk of getting in a crash or hitting a pedestrian or bicyclist. North American regulations permit both good and bad implementations. If you are trying to disable the DRLs preparatory to "converting" your headlamps with an "HID kit", be advised such kits are dangerous and illegal in every single case.
Check to make sure your parking brake is completely off. Whenever you set the parking brake, there is an electrical connection that shuts off the drls. Look up under the dash on the driver's side where the parkign brake lever is and look at the connections. The only way the DRLs come on is when the parkign brake is completely off. Even one click will keep the DRLs from coming on. Look there for a possible answer.
Your headlights are your DRLs
There is no switch for them - the best way is to pull the fuse.
depress the emergency brake. That will shut off the DRLs.
How do you disable the DRLs on a 2005 Mitsubishi Endeavor?
The simplest way to disable the DRLs on this vehicle would be to simply press the parking break pedal down JUST a hair. However, you will have to deal with the emergency brake light being on in your cluster panel.
DRLs didn't become standard on Cadillacs until 1996.
It's not manually possible like it was on previous Wrangler model since the DRLs are programmed in the computer. You need to go to your dealer and ask them to configure it in the "Import" mode. Your DRL will then be deactivate. Note that this since this is theoretically illegal, your dealer could refuse to do that.
The relay under the dash is either disconnected (a lot of people do this) or it isn't working.
If it doesn't have the daylight sensor on the dash, you should be able to turn the DRLs off by applying the emergency brakes.