Carefully remove the dash shell piece . it will pop free , clips only , but you will need to put the gear selector in the lowest position at some point . Three 7 mm hex screws hold the radio in place Remove red battery cable from the battery Remove the three screws , they are about an inch long so a socket on a shaft in a portable drill is effective gently pull radio forward , power and speaker wires and attenna attachment at the rear . If it takes more then 15 minutes you are thinking about it to hard . It really is this simple
put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.
FIRST YOU HAVE TO REMOVE THE FACE OF YOUR dash IT JUST POPS OFF... THEN U CAN SEE THE RADIO JUST UNSCREW THEN PULL OUT THEN UNPLUG WIRE HARNESS.
u have to go to the shop and buy it and pay the shop to install it
you have to remove the front console. take out the ash trey. and remove all the screws around the trim of the area of the stereo and then slid the stereo out and un hook all connections. if you get a new stereo it should have more detailed instructions
No.
to start off you have to pull off the dash trim around the raideo and the dash. once you do that their are 2 clips one on each side of the raideo you just push them down and pull and out comes the raideo.
you sell the truck
try www.haynes.com
no sorry
I remove my stereo from my GMC Truck and now my lights don't work
cut seals and gently remove
IF it is a 1/2 ton truck then a 4l60E belongs in it from the factory. IF it is a 3/4 ton truck then a 4l80E was factory in it.