Want this question answered?
To remove the valve cover on a 92-97 Toyota paseo. Remove the spark plug igniters from valve cover. Remove crankcase ventilation valve(black plastic 90 degree elbow) from valve cover and intake manifold. remove the fiev nuts on th top o the valve cover. place a pry bar between cylinder head and valve cover at the corners where they have left a gap. Pry slowly and easily. be sure to work all corners not just one.
Remove the screws in the wheel wells and underneath the plastic cover to remove the bumper cover. Then you can see to remove the actual bumper.
No, the bodystyle changed from 1994 to 1995, so 91-94 are the same bodystyle, and 95-98 is the second bodystyle
You can replace the radio, on your 1996 Toyota, I removing the radio front cover. Remove the retaining screws. Unplug the wiring harness. Reverse the process to install the new radio.
REMOVE TWO TOP BOLTS ON HEADLAMP ASSY. THEN REMOVE BUMPER COVER, THATS RIGHT THE BUMPER COVER, THEN REMOVE TWO BOTTOM BOLTS
Hi, I was looking for instructions as to "How to replace 1998 Toyota Camry rear bumper cover" and you got your question. If you have already replaced then please let me know otherwise I'm going to replace the part this weekened and I will let you know. Take care, Sam
To remove the rear bumper cover on a 1993 Ford Taurus wagon, the lights need to be disconnected in the rear. Once all electrical connections are disconnected in the rear, remove the taillights and the fuel filler overflow hose. Remove any nuts and bolts holding the bumper cover on. Using needle nose pliers, pop the push pins around the bumper cover upwards. Slowly pull on the bumper to remove it.
I think you asked the same question twice (just in different forms). The answer to both is the same. 1. Remove front bumper cover (to expose headlight housing lower attachment bolt) 2. Remove light bulbs from housing 3. Remove bolts attaching housing and lift away from bumper Removal of the bumper cover will be easier if you have a manual. Chilton, Haynes both offer Solara manuals or download the factory service manual from Toyota's website. Cheers
rip it off
,
1. If needed raise vehicle and support it on Jack stands 2. Remove the retaining screws in the wheel wells and along the upper and lower edges of the bumper cover. Remove the tail light housings. Remove the rear trim plate and pull luggage compartment trim out for access then remove the remaining bumper cover retaining screws. Remove the bumper bolts 3. On station wagons remove the rear window washer fluid reservoir for access to the bumper retaining bolts. The remaining bumper bolts are accessible from below 4. Pull the bumper and cover assembly out and away from the car
Unbolt the front of the wheel well liner inside the wheel opening.Remove the bumper cover bolt from the bracket located inside of the bumper at the end.AT the front of the car, remove the bolts holding the bumper cover on, located underneath the vehicle.You should now be able to remove the bumper cover from the front of your Dodge Intrepid.An instructional video has been included to show you the removal process.