use a slide hammer to remove the hub from the bearing. do this on the car. or remove complete knuckle and press hub out with a press
Remove wheel. Remove grease cup. Remove caliper & secure it so it does not interfere with spindle. Remove brake disc. Remove hub nut. Remove hub & bearing assembly. Use a two jaw pulley to remove hub if you can't do it by hand. Reverse procedure to install.
The hub is pressed in. Remove the knuckle with the hub and bearing in it and take it to local machine shop.
There are two tools needed to remove a front hub from a 2003 Frontier. These include a screwdriver and a cone wrench.Ê
The front hub takes a 35mm deep socket. (It is not necessary to remove the hub to change the rotor.)
Remove brake caliper, then caliper mounting. Now tap back of rotor to remove it. Detach tie rod end from knuckle, remove ABS sensor (this is very tricky, they stick) Remove control arm from knuckle, Now undo large nut holding hub and drive axle and pull hub off. Now remove the 3 bolts holding bearing assembly. Replace in reverse order.-This job is quite tricky if you are not a very experienced mechanic - I would highly recommend getting the Haynes manual .
# Raise and safely support the vehicle securely on jackstands. # Remove the brake caliper assembly. # Remove the front disc brake caliper anchor plate. # Remove the hub grease cap. # Remove the cotter pin. # Remove the spindle nut. # Remove the front wheel outer bearing retainer washer. # Remove the outer front wheel bearing. # Remove the hub grease cap gasket. # Remove the front disc brake hub and rotor. # Remove the wheel hub grease seal. # Remove the inner front wheel bearing.
you cant
The axle nut looks like it has a retainer on it but it's just a part of the nut! put a wrench on it and turn it off!
i front or rear.
Buy a new hub
YES!!!
remove the wheel remove the brake caliper braket assembly remove rotor.remove the axle shaft to hub nut remove hub retaining bolts.remove hub probably with hammer.big hammer.install new hub reverse proceedure