On my 2001 Aztek, I could pull the key out when driving. To change the ignition without removing the steering wheel, take the two screws out from underneath the covering behind the wheel. Not the screws on the steering wheel. The cover will lift up but won't come off. Take an Alleen wrench and feel for the hole on top of the ignition (it will be a tight squeeze), and push in. I should also say remove the black or gray cover on the ignition switch (where the key goes in). Once you find the hole and push down on it, the ignition switch will come out.
Where is the fuel shut off on 2002 aztek
To replace a turn signal switch on a 2003 Pontiac Aztek, also known as a flash relay, the steering column must be removed. The flash relay is located under the turn signal. Remove the mounting hardware and the unit can be taken off.
Pontiac Aztek was created in 2001.
go to http://www.programyourremote.com/ It works perfect. When you remove and reinsert the key per the instructions, remove it and swing it about 2 feet away from the ignition so the sensor can't detect the passcode in the key.
I am having the same problem with my 2005. I have been discontecting the battery to turn the car off, but now I can not get it to pass inspection because the catylist and evaporation sensors will not read ready.
fuse abs pontiac aztek 2002 located
a bad fuse of a faulty switch.
It is mounted on the top of the fuel tank. Just remove it.
It could be the electrical ignition system. there is a recall, dealers will replace the ignition relay free of charge. check it out. Pontiac tele. #1-800-620-7668
I just CAREFULLY slid a medium flat screwdriver under it. Not sure if it it the right way but worked fine for me on all 4 doors. DeBar